Speedstream 5200 Firmware Update Instructions

* Please print instructions before proceeding.

1. Download the Speedstream 5200 E240_A50_78-52_6100_78-60_v1r firmware update utility.

2. Locate the firmware update utility that you saved to your hard disk in step 1, and double-click the icon. This will launch the update utility.

3. The utility will first ensure that your Speedstream 5200 is attached to your PC. Once the utility discovers the Speedstream 5200, the "Update Firmware " button will become active.

Click the "Update Firmware".

4. The utility will report "Downloading Firmware" & the pwr LED on your Speedstream 5200 will flash alternating green/red during this update.

5. After you receive the message "The update completed successfully!", Click "OK" & close the firmware update utility by clicking the "X" in the upper right hand corner of the utility.

6. Powercycle the Speedstream 5200. Powercyling involves unplugging the power from the 5200 and plugging it back in.

Open a supported browser and type the following URL http://192.168.254.254 and click "Go".

7. The modem management interface will prompt for a username and password to access the setup screen.

Enter "admin" for the username, Enter "admin" for the password.

8. The management interface will then load and prompt for the ISP username and password. Enter your username and password provided by your ISP. Access Concentrator and Service Name should be left blank.

9. Ensure "Auto-Connect on Disconnect is check and click on "Save Settings".